Feasibility of using solid sampling graphite furnace atomic absorption spectrometry for speciation analysis of volatile and non-volatile compounds of nickel and vanadium in crude oil

A method for the direct determination of volatile and non-volatile nickel and vanadium compounds in crude oil without previous treatment using direct solid sampling graphite furnace atomic absorption spectrometry is proposed. The crude oil samples were weighed directly onto solid sampling platforms using a microbalance and introduced into a transversely heated solid sampling graphite tube. In previous work of our group losses of volatile nickel and vanadium compounds have been detected, whereas other nickel and vanadium compounds were thermally stable up to 1300 and 1600 °C, respectively. In order to avoid this problem different chemical modifiers (conventional and permanent) have been investigated. With 400 μg of iridium as permanent modifier, the signal started to drop already after two atomization cycles, possibly because of an interaction of nickel (which is a catalyst poison) with iridium. Twenty micrograms of palladium applied in each determination was found to be optimum for both elements. The palladium was deposited on the platform and submitted to a drying step at 150 °C for 75 s. After that the sample was added onto the platform and submitted to the furnace program. The influence of sample mass on the linearity of the response and on potential measurement errors was also investigated using four samples with different nickel content. For the sample with the lowest nickel concentration the relationship between mass and integrated absorbance was found to be non-linear when a high sample mass was introduced. It was suspected that the modifier had not covered the entire platform surface, which resulted in analyte losses. This problem could be avoided by using 40 μL of 0.5 g L⁻¹ Pd with 0.05% Triton X-100. Calibration curves were established with and without modifier, with aqueous standards, oil-in-water emulsions and the certified reference material NIST SRM 1634c (trace metals in residual fuel oil). The sensitivity for aqueous standards and emulsions was close to that for SRM 1634c, making possible the use of aqueous standards for calibration. The limits of detection and quantification obtained for nickel and vanadium under this condition were found to be 0.02 and 0.06 μg g⁻¹, respectively, for both elements, based on 10 mg of sample. Nickel and vanadium were determined in the samples with (total Ni and V) and without the use of Pd (thermally stable compounds), and the concentration of volatile compounds was calculated by difference. The results were compared with those obtained by high-resolution continuum source graphite furnace atomic absorption spectrometry by emulsion technique; no significant differences were found for total Ni and V at the 95% confidence level according to a Student's t-test.     

ADSORPTION OF 2,4-DICHLOROBENZOXYACETIC ACID ONTO HYPERCROSSLINKED RESIN MODIFIED BY PHENOLIC HYDROXYL GROUP (AM-1)

INTRODUCTIONAdsorption has been considered to be the best available technology for removing organics from water in the USSafe Drinking Water Act[1]. Due to many drawbacks of activated carbon[2-7], the most widely used adsorbent,hypercrosslinked polymeric adsorbents developed by Tsyurupa and Davankov[8] have been increasingly viewedas an alternative to activated carbon for selective removal of specific organic substances from contaminatedwater[9-12], and series of researches have been do…     

Semiempirical calculation of electronic spectra of organic compounds by using the improved method of new-γ electron repulsion integral. Part 2. Polycyclic aromatic hydrocarbons (PAHs)

Excitation energies of 123 polycyclic aromatic hydrocarbons were calculated by incorporating the improved method of new-γ for the two-center electron repulsion integral into two semiempirical molecular orbital methods (CNDO/S and INDO/S). This variable method well reproduced experimental excitation energies of them. The average error of the improvement is about 0.162 (CNDO/S) or 0.237 eV (INDO/S) though the average error without the improvement is about 0.541 (CNDO/S) or 0.536 eV (INDO/S). The improvement was useful for the calculations of other organic compounds including hetero atoms, such as organic dye.     

丙酮肟与某些芳烃相互作用的~1H核磁共振研究

Hatton和Richards通过对酰胺分子的~1H NMR谱溶剂效应的研究,提出了DMF与苯生成分子络合物的模型.如果络合物按1:1生成,那么将出现一个“饱和点”,在这点上甲基的芳香溶剂诱导位移(ASIS)的变化趋势或程度将出现一个明显的变化,事实上随着苯的摩尔分数从0到1逐渐增加时,化学位移总是有规则的逐渐移向高场.这就显示了分子络合物观点的局限性.它能被一些研究者所支持和接受,是因为它能够解释两个甲基共振峰先重合而后又分离的现象.     

Geometry,stability and aromaticity of β-diketiminate-coordinated alkaline-earth compounds

Alkaline-earth (Ae) metals have attracted a wealth of interdependent research from synthetic chemists. In Ae-catalyzed organometallic reactions, β-diketiminate is a typical ligand used to stabilize Ae catalysts by forming six-membered rings comprising Ae metals. Herein, studies focusing on the configuration of β-diketiminate-coordinated Ae compounds observed that the CC and CN bonds are homogeneous and unchanged. Furthermore, energetic studies observed that the formation of the Ae-incorporated six-membered rings results in enhanced stability of >20 kcal/mol. The nucleus-independent chemical shifts, anisotropy of the induced current density, and molecular orbital analyses demonstrated the non-aromaticity of the β-diketiminate-coordinated Ae compounds. The improved stability of these compounds can be explained by the delocalization of the π electrons derived from the β-diketiminate moiety.     

纳米二氧化钛-高锰酸钾协同光催化氧化体系快速测定化学需氧量

以纳米TiO2-KMnO4协同光催化氧化体系为基础,结合分光光度法建立了一种快速测定水样中化学需氧量(COD)的简便方法。本方法具有线性范围宽、抗氯离子干扰能力强等优点。在选定的最优条件下,线性范围为0.1~320mg/L;当氯离子含量在1500mg/L以内时,相对误差小于5%。此方法适用于污染程度低的自来水、地表水或中等污染程度的工业废水中COD值的快速测定。     

Simulation of aerated lagoon using artificial neural networks and multivariate regression techniques

The aim of this study was to develop an empirical model that provides accurate predictions of the biochemical oxygen demand of the output stream from the aerated lagoon at International Paper of Brazil, one of the major pulp and paper plants in Brazil. Predictive models were calculated from functional link neural networks (FLNNs), multiple linear regression, principal components regression, and partial least-squares regression (PLSR). Improvement in FLNN modeling capability was observed when the data were preprocessed using the PLSR technique. PLSR also proved to be a powerful linear regression technique for this problem, which presents operational data limitations.     

Highly visible-light luminescence properties of the carboxyl-functionalized short and ultrashort MWNTs

Luminescence of the short multiwalled carbon nanotubes (MWNTs) conjugated with carboxylic acid groups has been studied. The results show that the carboxyl-functionalized short MWNTs could emit luminescence and the emission peak appears at 500 nm with a corresponding optimal excitation wavelength centering at 310 nm. When the short MWNTs are filtered through 0.15 μm polytetrafluoroethylene (PTFE) membrane, the ultrashort MWNTs are obtained from the filtrate. An interesting feature for the ultrashort MWNTs is that the emission intensity is strengthened and the peak is slightly blue shifted to 460 nm. This result indicates that the luminescence properties of MWNTs are strongly affected by the tube length. After chemical oxidization cutting, defects and carboxylic acid groups at the tube end and/or sidewall can be produced; the more shorten of MWNTs, the better dispersion and carboxylic passivation of the nanotubes, and the more intense luminescence emissions. The broad emissions are logically attributed to the trapping of excitation energy by defect sites in the carboxyl-functionalized nanotube structure.